Filter
Top Products
20- ENG
D30333
4. Turn control valve toward tank to
be drained.
5. Repeat steps 3-4 to drain second
tank.
6. Turn control valve knob to the
down (off) position.
7. Fill tanks with clean water.
8. Turn valve toward tank and drain
water from tank. Repeat on
second tank. NOTE: This will rinse
cleaning solution tanks.
9. Route the cleaning solution hose
over the axle and reconnect
cleaning solution hose to chemical
injector for future use.
7. Add *RV antifreeze to hose as
shown.
8. Pull engine starter rope slowly
several times until antifreeze
comes out of high pressure hose
connection of pump.
9. Remove short hose from water
inlet of pump.
10. Reconnect spark plug wire.
* Windshield washer fluid may also be
used
DUAL TANK CLEANING
SYSTEM
1. Turn control valve knob to the
down (off) position.
2. Remove cleaning solution hose at
chemical injector and pull it over
the axle and to the rear of the unit.
3. Place end of cleaning solution
hose into a suitable container to
drain cleaning solution.
Control Valve Knob
Axle
Hose