Filter
Top Products
13 — ENG
D20346 Rev. 0 2/28/00
• Move ON/OFF switch located on the front panel of
the engine to the "ON" position.
You MUST unplug any load
from the generator before starting to prevent
permanent damage to any appliances.
• Grasp handle on rope starter and pull slowly until
resistance is felt. Let the rope rewind slowly. Pull
rope with a rapid full arm stroke. Let rope rewind
slowly. Repeat if necessary.
• When engine starts, gradually move the choke to
the "NO CHOKE" position.
IMPORTANT: Allow generator to run at no load for 5
minutes upon each initial start-up to allow engine and
generator to stabilize.
STOPPING ENGINE
• Disconnect all electrical loads.
• Turn ON/OFF switch to "OFF" position.
• Close fuel shut-off valve.
NOTE: When engine is transported, close fuel shut-
off valve to prevent leakage.
IMPORTANT: Never store engine with fuel in tank,
indoors, or in enclosed, poorly ventilated areas or
where fuel fumes may reach an open flame.
CONNECTING ELECTRICAL LOADS
• Let engine run and warm up for five minutes after
starting with no electrical load.
Connect loads in the following manner to prevent
damage to equipment:
• Connect inductive load equipment first, inductive
loads consist of refrigerators, freezers, water
pumps, air conditioners, or small hand tools.
Connect the items that require the most wattage
first.
• Connect the lights next.
• Voltage sensitive equipment should be the last
equipment connected to the generator. Plug
voltage sensitive appliances such at TV's, VCR's,
microwaves, ovens, computers, and cordless
telephones into a UL listed voltage surge protec-
tor, then connect the UL listed voltage surge
protector to the generator.
IMPORTANT: You should always add up the rated
watts of all lights, tools and appliances you are
powering at one time. This total should not
exceed the rated capacity of you generator or
circuit breaker rating of the receptacle supplying
power.
ON/OFF Switch
Fuel Shut-off
Valve
ON/OFF Switch