Filter
Top Products
2. Positiononeofthebracketcovers
undertheuppershaftandalignthe
mountingbracketandthebracket
coverscrewholes.Inserttwo
screwsintothescrewholes.
3. Securethemountingbracketby
tighteningthescrewswiththehex
wrench.
4. Locatethedecalonthehandlebar.
Thisdecalincludesanarrow.Posi-
tionthehandlebarwiththemount-
ingbracketattheendofthearrow.
5. Positionthesecondbracketcover
overthehandlebar.Alignthemount-
ingbracketandthebracketcover
screwholes.Againmakesurethe
handlebarisattheendofthearrow.
6. Inserttwoscrewsandhandtighten
only.Besurethehandlebaris
installedcorrectly;then,tighteneach
screwsecurelywiththehexwrench.
SHOULDER STRAP ASSEMBLY
WARNING: Proper shoulder strap
and handlebar adjustments are required
before use. The shoulder strap clamp
must be installed as shown above the
handlebar on the upper shaft (power-
head end of unit).
NOTE: The lower shoulder strap
clamp has two spacer tabs attached.
These tabs are provided to adapt this
attachment for use with powerheads
that have a 1" diameter upper shaft
(the shoulder strap clamp will not tight-
en down securely on the 1" diameter
upper shaft without using these spacer
tabs). The tabs must be broken off
completely before use and placed over
the screw holes on the lower shoulder
strap clamp. These tabs are not need-
ed for powerheads with a 7/8" upper
shaft.
LOWER SHOULDER STRAP
CLAMP
41;_L-_,_- Spacer Tabs
positioned for use
on 1" diameter
upper shaft
1,
2.
Place the upper shoulder strap
clamp over the upper shaft above
the handlebar.
Position the lower shoulder strap
clamp under the upper shaft and
align the upper and lower clamp
screw holes (use spacer tabs be-
tween upper and lower clamps if
necessary to secure clamp, i.e. for
1" diameter upper shaft).
POWERHEAD
END
Upper Shoulder
Clamp
l ATTACHMENT
Lower Shoulder END
Strap Clamp
Screws
3. Insert two screws into the screw
holes.
4. Secure shoulder strap clamp by
tightening screws with the hex
wrench.
5. Insert your right arm and head
through the shoulder strap and al-
low it to rest on your left shoulder.
Make sure the danger sign is on
your back and the hook is to the
right side of your waist.
NOTE: A one-half twist is built in the
shoulder strap to allow the strap to rest
flat on the shoulder.
6. Adjust the strap, allowing the hook
to be about 6 inches below the
waist.
7. Fasten the strap hook to the upper
clamp and lift the tool to the oper-
ating position.
8. Try on shoulder strap and adjust for
fit and balance before starting the
engine or beginning a cutting opera-
tion.
NOTE: It may be necessary to
relocate the shoulder strap clamp on
the shaft for proper balancing of unit.