Craftsman 917.77341 Trimmer User Manual


 
TRIMMER
Always observe safety rules when perform-
ing any maintenance.
TIRES
Keep tires free of gasoline, oil, or insect
control chemicals which can harm rubber.
Avoid stumps, stones, deep ruts, sharp
objects and other hazards that may cause
tire damage.
TRIMMER LINE
For best results, replace trimmer lines
when they have worn to half their original
length. Use .130 inch diameter trimmer
line. Cut new trimmer line length to 16-314
inches. After new line is installed on
trimmer head, check all lines so they do
not vary more then one (1) inch in length.
This is important to make sure the trimmer
head is balanced and will not vibrate
abnormally.
_WARNING: Use only the specified
trimmer line. Do not use other materials
such as wire, string, rope, etc. Wire can
break off during trimming and become a
dangerous missile that can cause serious
injury.
TO REPLACE TRIMMER LINE
Disconnect spark plug wire from spark
plug and place wire where it cannot
come in contact with spark plug.
Remove worn trimmer line from line
carrier plate.
Fold new, cut to length, trimmer line in
half and insert folded end through
carrier plate opening to back side of
retainer clip.
With folded end of line at back side of
retainer clip, pull line outward until line
is fully seated under the retainer clip.
Repeat on other side of carrier plate.
Check all lines to be sure they are the
same length.
Reconnect spark plug wire to spark
plug.
Trimmer
line
Carrier plate
opening
\
\
Retainer
clip
ENGINE
LUBRICATION
Use only high quality detergent oil rated
with API service classification SF, SG or
SH. Select the oil's SAE viscosity grade
according to your expected operating
temperature.
SAE VISCOSITY GRADES
NOTE: Although multi-viscosity oils
(5W30, 10W30 etc.) improve starting in
cold weather, these multi-viscosity oils
will result in increased oil consumption
when used above 32°F. Check your
engine oil level more frequently to avoid
possible engine damage from running
low on oil.
Change the oil after every 25 hours of
operation or at least once a year if the
lawn mower is not used for 25 hours in
one year.
Check the crankcase oil level before
starting the engine and after each five (5)
hours of continuous use. Tighten oil plug
securely each time you check the oil
level.
10