Craftsman 917.389020 Lawn Mower User Manual


 
The operation of any lawn
SAFETVG'ASSESmower can result in foreign
objects thrown into the eyes,
which can result in severe
eye damage. Always wear
safety glasses or eye shields while oper-
ating your lawn mower or performing any
adjustments or repairs. We recommend a
standard safety glasses orwide vision safety
mask worn over spectacles.
HOW TO USE YOUR LAWN MOWER
ENGINE SPEED
Engine speed was set at the factory for
optimum performance. It is not adjustable.
ENGINE ZONE CONTROL
_I, CAUTION: Federal regulations require
an engine control to be installed on this
lawn mower in order to minimize the
risk of blade contact injury. Do not under
any circumstances attempt to defeat the
function of the operator control. The blade
turns when the engine is running.
Your lawn mower is equipped with an
operator presence control bar which
requires the operator to be positioned
behind the lawn mower handle to start
and operate the lawn mower.
TO ADJUST CUTTING HEIGHT
Raise wheels for low cut and lower wheels
for high cut, adjust cutting height to suit
your requirements. Medium position is
best for most lawns.
To change cutting height, squeeze ad-
juster lever toward wheel. Move wheel
up or down to suit your requirements. Be
sure all wheels are in the same setting.
NOTE: Adjuster is properly positioned when
plate tab inserts into hole in lever. Also, 9-
position adjusters (if so equipped) allow lever
to be positioned between the plate tabs.
LEVER BACKWARD
TO LOWER MOWER
Plate tab
LEVER FORWARD TO RAISE MOWER Lever
TO CONVERT MOWER
Your lawn mower was shipped ready to be
used as a mulcher. To convert to bagging
or discharging:
REAR BAGGING
Lift rear door of the lawn mower and
place the grass catcher frame hooks
onto the door pivot pins.
To convert to mulching or discharging
operation, remove grass catcher and
close rear door.
Pivot pins Rear
Grass
catcher
handle
Catcher frame hook
SIDE DISCHARGING
Rear door must be closed.
Open mulcher door and install dis-
charge deflector under door as shown.
Mower is now ready for discharging
operation.
To convert to mulching or bagging opera-
tion, discharge deflector must be removed
and mulcher door must be closed.
Open mulcher door
Discharge deflector
\
I
I
8
MOWER IS NOW
READY FOR
DISCHARGING
OPERATION
I
I