Filter
Top Products
• To change from medium low to high
position only the upper handle section
will have to be turned over.
• To change from medium low to low
position, only the lower handle section
will have to be turned over.
Shipping Position
_Medium
Medium
low
High Low
Squeeze to
remove
Lower handle
Handle
bracket
Mountin_O
Hairpin clip pin
ENGINE
CARBURETOR
Your carburetor has a non-adjustable fixed
main jet for mixture control. Ifyour engine
does not operate properly due to suspected
carburetor problems, take your lawn mower to
an authorized service center for repair and
adjustment.
IMPORTANT: Never tamper with the
engine governor, which is factory set for
proper engine speed. Overspeeding the
engine above the factory high speed
setting can be dangerous, if you think the
engine-governed high speed needs
a_ljusting, contact your nearest AUTHO-
RIZED service center, which has proper
equipment and experience to make any
necessary adjustments.
ENGINE SPEED
The engine speed has been factory set. Do
not attempt to increase engine speed as it
may result in personal injury. If you believe the
engine is runningtoo fast ortoo slow, take
your lawn mower to an authorized service
center for repair and adjustment.
Immediately prepare your lawn mower for
storage at the end of the season or ifthe unit
will not be used for 30 days or more.
LAWN MOWER
When lawn mower is to be stored for a period
oftime, dean itthoroughly, remove all dirt,
grease, leaves, etc. Store in a clean, dry area.
• Clean entire lawn mower (See "CLEAN-
ING" in the Maintenance section of this
manual).
• Lubricate as shown in the Maintenance
section of this manual.
• Be sure that all nuts, belts, screws, and pins
are securely fastened. Inspect moving
parts for damage, breakage and wear.
Replace if necessary.
• Touch up all rusted or chipped paint
surfaces; sandT_jhtly before painting.
HANDLE
You can fold your lawn mower handle for
storage.
• Squeeze the bottom ends of the lower
handle toward each other untilthe lower
handle clears the handle bracket, then
move handle forward.
• Loosen upper handle mounting belts
enough to allow upper handle to be folded
back.
IMPORTANT: When folding the handle for
storage or transportation, be sure to fold the
handle as shown or you may damage the
controlcables.
• When setting up your handle from the
storage position,the lower handle will
automatically lock into the mowing position.
1;
Squeeze tofold
Hairpin cotter
I pin