Filter
Top Products
TROUBLESHOOTING CHART
CAUSE
=ROBLEM
]oes not start
_oor performance
_OOFCUt-- uneven
;xcess{ve
tibration
o Fuse has been
removed from mower
o Charger has not been
unplugged from mower
charge port
o Battery may need [o be
recharged
o Blade does not rotate freely
or mower deck is clogged
• Grass too high or thick
(Overload light is on 25%
of the time)
, Low battery voltage (Low
power fight stays on while
mowing)
. Worn, ben[ or loose Made
. Wheel heights uneven.
* Buildup of grass, and trash
leaves, under mower.
- Worn, bent or loose blade
o Bent molor motorshalt.
CORRECTION
, Install fuse
• Remove charger plug from
mower charge pod
• Charge battery
° Remove fuse, turn mower
on itssideandcheckblade.
Make sure it is free to
rotate.
Also check {or clogging,
• Raise mower cutting height
to cut 1/3 of grass length
. Wall< at a slower pace so
ovedoad light stays off.
. Reduce cutting width if
needed.
. Remove fuse, check
deck for clogging, check
blade for sharpness
o Reduce cutting load
,, Walk at slower pace
• Reduce cutting width
- Raise cutting height
. Recharge balteries
• Remove fuse.
• Replace blade, Tighten
blade bolt.
• Set all wheels at same
height.
, Remove fuse and cleanun-
derside of mower housing_:,
o Remove fuse
• Replace blade. Tighten
blade bolt,
o Contact an autholized
service center:
15