Filter
Top Products
CUSTOMER
BILITIES
ENGINE
LUBRiCATiON
Use onty high quality detergent oil rated with API service
classification SF or SG. Select the oit's SAE viscosity grade
according to your expected operating temperature.
SAE VISCOSITY GRADES
.20 _ 0 o 30° 32_ 40 ° 609 80 ° 100 °
IC .30° .20 ° .i0 ° 0o 10_ 20_ 30 •
TEMPERATURE RANGE ANTICIPATED BEFORE NEXT OIL CHANGE
NOTE: Although multi-viscosity oils (5W30, 10W30 etc.)
improve starting in cold weather, these multi-viscosity oils
wil! result in increased oi! consumption when used above
32'_F. Check your engine oil level more frequently to avoid
possible engine damage from running low on oil.
Change the oil after the first two hours of operation and
every 25 hours thereafter or at least once a year ifthe lawn
mower is not used for 25 hours in one year,
Check the crankcase oil level before starting the engine
and after each five (5) hours of continuous use. Tighten oil
p!ug securely each time you check the oil level.
TO CHANGE ENGINE OiL (See Fig, 12)
NOTE: Before tippmg lawn mower to drain oil, drain fuel
tank by running engine until fuel tank is empty.
Disconnect spark plug wire from spark plug and place
w_rewhere t cannot come in contact with spark plug.
• Remove engine oil cap; lay aside on a clean surface.
= Tip lawn mower on its side and drain oil into a suitable
container. Rock Iawn mower back and forth to remove
any oiJ trapped inside of engine.
= Wipe off any spilled oil on lawn mower and on side of
engine,
• Fill engine with oil. Fill only to the "FULL" line on the
dipstick. DO NOT OVER FILL.
Replace engine o_1cap.
= Reconnect spark plug wire to spark plug.
CONTAINER
FIG. 12
AiR FILTER
Your engine will not run properly and may be damaged by
using a dirty air filter.
Replace the air filter every year, more often if you mow in
very dusty, dirty conditions. Do not wash air filter.
TO CHANGE AIR FILTER (See Fig. 13)
- Loosen cover screw.
, Swing cover down and remove from hinge.
- Pull paper fiiter out of air cleaner body,
= Clean air cleaner cover and body,
- Install a new paper filter.
= Reinstall cover to air cleaner body. Be sure hinge is
assembled properly.
- Swing cover up and tighten cover screw. (Do not
overtighten),
AIR FILTER
COVER
/
/
HINGE /
/
PAPER
FILTER
COVER
SCREW
FIG. 13
MUFFLER
Inspect and replace corroded muffler as it could create a
fire hazard and/or damage.
SPARK PLUG
Change your spark plug each year to make your engine
start easier and run better, Set spark plug gap at .030 inch.
CLEANING
IMPORTANT: FOR BEST PERFORMANCE. KEEP
MOWER HOUSING FREE OF BUILT-UP GRASS AND
TRASH. CLEAN THE UNDERSIDE OF YOUR MOWER
AFTER EACH USE.
_1_ from spark plu_ace wire_where !t !
cannot come in contact with the spark
* Turn ;awn mower on its side. Make sure air filter and
carburetor are up. Clean the underside of your lawn
mower by scraping to remove build-up of grass and
trash.
, Clean engine often to keep trash from accumulating. A
clogged engine runs hotter and shortens engine life.
o Keep finished surfaces and wheels free of all gasoline,
oit.etc,
We do not recommend using a garden hose tc clean
lawn mower unless the electrical system, muffler, air
filter and carburetor are covered to keep water out,
Water in engine can result in shortened engine life.
CLEAN UNDER DRIVE COVER
Clean under drive cover at beasttwice a season. Scrape
underside of cover with putty knife or similar tool to remove
any build-up of trash or grass on underside of drive cover.
t4