Filter
Top Products
4. Reinstallblade.
5. Returnmower to upright position.
6. Push down on arm, install new belt on
gearcasepulley. Releasearm slowly.
NOTE:Always usefactory approvedbelt
to assure properfit andlong life.
7. Reinstalldrive cover.
Engine pulley
Belt
retainer
Debris shield
Drive belt
Lower
handle
TO ADJUST HANDLE
The handle can be mounted in a high or
low position. The mounting holes in the
bottom of lower handle are off center for
raising or lowering the handle.
1. Remove upper handle and all wire tie(s)
securing cable(s) to lower handle.
2. Remove hairpin cotters from lower
handle bracket mounting pin.
3. Squeeze lower handle in to remove it
from mounting pins.
4. Turn lower handle over to raise or
lower handle.
5. Squeeze lower handle in and position
holes onto mounting pins on bracket.
6. Reassemble upper handle and all parts
removed from lower handle.
SQUEEZE 1
TO ADJUST
[_ _ Lower handle ,
I_hJ _ Mounting pin
I_11 Handle
I_ I bracket Hairpin cotter I__B_j
ROTATE
ENGINE
ENGINE SPEED
Your engine speed has been factory set.
Do not attempt to increase engine speed
or it may result in personal injury. If you
believe that engine is running too fast or
too slow, take your mower to a Sears or
other qualified service center for repair
and adjustment.
CARBURETOR
Your carburetor is not adjustable. If your
engine does not operate properly due
to suspected carburetor problems, take
your lawn mower to a Sears or other
qualified service center for repair and/or
adjustment.
IMPORTANT: Never tamper with the
engine governor, which is factory set for
proper engine speed. Overspeeding
the engine above the factory high speed
setting can be dangerous. If you think
the engine-governed high speed needs
adjusting, contact a Sears or other
qualified service center, which has proper
equipment and experience to make any
necessary adjustments.
15