Filter
Top Products
iNSTALL MOWER AND DRIVE BELT
Be sure tractor is on level surface and engage
parking brake.
1. Lower attachment lift lever to it's lowest
position.
A CAUTION: Lift lever is spring loaded.
Have a tight grip on lift lever, lower it slowly
and engage in lowest position.
2. Turn steering wheel to the left as far as it
will go and position mower on right side of
tractor with deflector shield to the right.
- Pivot bar towards you and insert other
end of bar into hole in rear mower bracket
(D). Move mower as needed to insert bar.
- Secure with washer and retainer spring
as shown.
3. Remove plastic tie securing belt, bring
belt forward and check belt for proper
routing in all mower pulley grooves.
NOTE: Be sure mower side suspension
arms (A) are pointing forward before sliding
mower under tractor.
6. ATTACH MOWER SIDE SUSPENSION
ARMS (A) TO CHASSIS - Position hole
in arm over pin (B) on outside of tractor
chassis and secure with retainer spring.
7. Repeat on opposite side of tractor.
4. Slide mower under tractor until it is cen-
tered under tractor.
5. FIRST INSTALL ANTI-SWAY BAR (S).
- From right side of mower, insert ant-sway
bar into hole in transmission bracket (T).
8. ATTACH REAR LIFT LINKS (C) - Insert
rod end of link assembly into hole in tractor
lift shaft suspension arm (L) and pivot link
down to mower. Lift rear corner of mower
and position slot in link assembly over pin
on rear mower bracket (D) and secure
with washer and retainer spring.
9. Repeat on opposite side of tractor.
10.Turn steering wheel to position wheels
straight forward.
9