Filter
Top Products
TO REMOVE WHEEL FOR REPAIRS
1. Block up axle securely.
2. Remove axle cover, retaining ring and
washers to allow wheel removal (rear
wheels have a square key _Do not Iose)_
3. Repair tire and reassemble°
NOTE; On rear wheels only: align grooves in
rear wheel hub and axle. Insert square key.
4, Replace washers and snap retaining ring
securely in axle groove.
5. Replace axle cover.
NOTE: To seal tire punctures and prevent
flat tires due to slow leaks, purchase and
use tire sealant from Sears. Tire sealant also
prevents tire dry rot and corrosion.
Washers
Retaining
Axle
Square
Key _._..,
(Rear Wheel Only) -_"-
TRANSAXLE MOTION CONTROL LEVER
NEUTRAL ADJUSTMENT
The motion control lever has been preset atthe
factory; adjustment should not be necessary.
1. Loosen adjustment bolt in front of the
right rear wheel, and lightly tighten.
2o Start engine and move motion control
lever until tractor does not move forward
or backward.
3. Hold motion control lever in that position
and turn engine off.
4. While holding motion control lever in
place, loosen the adjustment bolt.
5_ Move.motion control lever to the neutral
(lock gate) position,
6. Tighten adjustment bolt securely.
Motion Neutral
Lever Lock
Gate
_ ...., ! Adjustment Bolt
NOTE: If additional clearance is needed to
get to adjustment bolt, move mower deck
height to the lowest position.
After above adjustment is made, if the trac-
tor still creeps forward or backward while
motion control lever is in neutral position,
follow these steps:
1, Loosen the adjustment bolto
2. Move the motion control lever 1/4 to 1/2
inch in the direction it is trying to creep_
3. Tighten adjustment bolt securely.
4. Start engine and test°
5. if tractor still creeps, repeat above steps
until satisfied.
TO START ENGINEWITH WEAK BATTERY
AgAWARNING: Lead-acid batteries gener-
ate explosive gases_ Keep sparks, flame
and smoking materials away from batteries.
Always wear eye protection when around
batteries°
Ifyour battery is too weak to start the engine, it
should be recharged° (See "BATTERY" in the
MAINTENANCE section of this manual).
If "jumper cables" are used for emergency
starting, follow this procedure:
IMPORTANT: "four tractor is equipped with
a 12 volt system. The other vehicle must also
be a 12 volt system. Do not use your tractor
battery to start other vehicles.
TO ATTACH ,JUMPER CABLES -
1. Connect one end ofthe RED cable to the
POSITIVE (+) terminal of each battery(A-
B), taking care not to short against tractor
chassis.
2_ Connect one end of the BLACK cable
to the NEGATIVE (-) terminal (C) of fully
charged battery.
3. Connect the other end of the BLACK
cable (D) to good chassis ground, away
from fuel tank and battery.
TO REMOVE CABLES, REVERSE ORDER -
1. BLACK cable first from chassis and then
from the fully charged battery.
2. RED cable last from both batteries.
Weak or
Dead
Battery
Fully
Charged
Battery
25