Filter
Top Products
ASSEMBLE GAUGE WHEELS TO
MOWER DECK
The gauge wheels are designed to keep
the mower deck in proper position when
operating mower.
1. Slide gauge wheel bar down into
bracket channel, Be sure that gauge
wheel bar aligning holes are on top.
Assemble gauge wheels as shown
using shoulder bolts, 3/8 washers and
3/8-16 center Iocknuts and tighten
securely.
2. For ease of mower to tractor assembly,
set all the gauge wheels in the fourth
hole from top. Retain with clevis pins
and spring retainers.
Shoulder
Bolt_ Adjusting
Gauge Wheel
3/8 Washer
_ 3/8-16 Center
Locknut
i
Set All Wheels
To 4th Hole
From Top
INSTALL MOWER AND DRIVE
BELT
See MOWER AND DRIVE BELT AS-
SEMBLY Supplement Sheet for additional
guidance on this assembly.
Be sure tractor is on level surface and
mower suspension arms are raised with
attachment lift control. Engage parking
brake.
1. Turn steering wheel to the left as far as
it will go and position mower on right
side of tractor with deflector shield to
the right.
2. Remove plastic tie strap from mower
belt and check belt for proper routing in
all mower pulley grooves.
3. Slide mower under tractor until it is
centered under tractor. DO NOT con-
nect any pins. When properly centered
the front mower brackets should be
aligned so when the front suspension
plate is lowered it should slide between
the mower brackets.
4. Lower attachment lift lever to lowest
position.
5. Cut plastic tie and lower front suspen-
sion plate.
6. ATTACH FRONT PLATE - From left
side of mower, position front plate as-
sembly between front mower brackets,
align holes, position flanged pin notch
vertically and insert the pin all the way.
The notch is in line with the hole in pin.
7. Secure pin with double loop retainer
spring between the plate and mower
bracket. If necessary, move mower
side-to-side to give space between
plate and mower bracket.
8. Go to right hand side of mower and
insert pin and retainer spring in the
same manner.
9. CONNECT REAR PINS - Connect
right hand side first. Pull out and hold
the spring loaded pin, align hole in
suspension arm and release pin. Be
sure pin returns to fully seated position
and is attached to the suspension arm.
10. Go to left side of mower and connect
rear pin in the same manner.
11. Disengage belt tension rod.
12. From right side of tractor, install belt
onto engine clutch pulley.
IMPORTANT: Check belt for proper rout-
ing in all mower pulley grooves.
13. Engage belt tension rod on locking
bracket.
& CAUTION: Belt tension rod is spring
loaded. Have a tight grip on rod and en-
gage slowly.
14. Raise attachment lift lever to highest
position.
15. Adjust gauge wheels before operating
mower as shown in the Operation sec-
tion of this manual.
10