Filter
Top Products
Yournew tractorhasbeenassembledat the factory. Reviewthe videocassettebefore
you begin.
When rightor left hand is mentionedin
this manual,it means,from yourpoint of
view,when youare in the operatingposi-
tion (seatedbehindthe steeringwheel).
TO REMOVE TRACTOR FROM
CARTON
UNPACK CARTON
1. Cut along dotted lines on all four pan-
els of carton. Remove end panels and
lay side panels flat.
2. Remove packing materials.
3. Remove protective materials from trac-
tor hood and grille.
IMPORTANT: Check for and remove any
staplesin skid that may puncture tires
where tractor is to roll off skid.
HOW TO SET UP YOUR TRACTOR
CHECK BATTERY
1. Lift hood to raised position.
NOTE: If this battery is put into service
after month and year indicated on label
(label located between terminals) charge
battery for minimum of one hour at 6-10
amps. (See "BATTERY" in Maintenance
section of this manual for charging instruc-
tions).
-_ ,- - Label
J
INSTALL SEAT
Seat position should be adjusted forward
or backward so that the operator can
comfortably reach clutch/brake pedal and
safely operate the tractor.
1. Remove the two (2) bolts and flat
washers securing the seat to card-
board packing. Keep the two (2) bolts
only and place them with the two (2)
identical bolts and four (4) washers in
the parts bag. Discard the flat washers
and cardboard packing.
2. Release L.H. seat slide on seat pan by
pulling out on adjustment handle and
sliding it to the rear position exposing
seat mounting holes from bottom. Slide
R.H. slide to same rear position.
3. Mount rear of seat on slides using
mounting bolts and lock washers as
shown.
4. Pull out on adjustment handle and
slide seat all the way forward. Install
front mounting bolts and lock washers.
Tighten all mounting bolts securely.
5. Lower seat into operating position and
sit on seat. Press clutch/brake pedal all
the way down. If operating position is
not comfortable, adjust seat.
To adjust seat: Grasp adjustment handle
and pull out, slide seat to desired position
and release adjustment handle.
Seat
L.h. Seat_
Slide _
Adjustment ^ / f/ "//)
Handle b_eat /,_7 z/'//
•ock
Washers__ i_'___
._,_ _ '_ R.H. Seat Slide
ount,n0 o,ts
NOTE: You may now roll or drive your
tractor off the skid. Follow the appropriate
instruction below to remove the tractor
from the skid.
TO ROLLTRACTOR OFF SKID (See
Operation section for location and
function of controls)
1. Press lift lever plunger and raise
attachment lift lever to its highest po-
sition.
2. Release parking brake by depressing
brake pedal.
3. Place freewheel control in transmission
disengaged position (See "To Trans-
port" in the Operation section of this
manual).
4. Roll tractor forward off skid.
7