Filter
Top Products
FRONTWHEELCAMBER
• Thefront wheel camber is not adjustable
on your tractor. If damage has occurred to
affect the front wheel camber, contact
contact a Sears or other qualified service
center
A
Adjustment Sleeves
Jam Nuts
TO REMOVE WHEEL FOR REPAIRS
FRONTWHEEL-
1. Block up axle securely.
2. Remove axle cover, retaining ring and
washers to allow wheel removal.
3. Repair tire and reassemble.
4. Replace washers and snap retaining
ring securely in axle groove.
5. Replace axle cover.
REAR WHEEL -
1. Block rear axle securely.
2. Remove five (5) hub bolts to allow
wheel removal.
3. Repair tire and reassemble. Replace
and tighten hub bolts securely.
NOTE: To seal tire punctures and prevent
fiat tires due to slow leaks, tire sealant
may be purchased from your local parts
dealer. Tire sealant also prevents tire dry
rot and corrosion.
Washem
Retaining
Ring'
Axle
Cover
TO START ENGINE WITH A WEAK
BATTERY
_hbcAIJTION: Lead-acid batteries generate
explosive gases. Keep spanks,flame and
smoking materials away from batteries.
Always wear eye protectionwhen around
batteries.
Ifyour battery is too weak to startthe engine, it
should be recharged. (See "BA'I-I'ERY" in the
MAINTENANCE sectionof this manual).
If"jumper cables" are used for emergency
starling, follow this procedure:
IMPORTANT: Yourtractoris equipped with a
12 volt negative grounded system. The other
vehical must also be a 12 volt negative
grounded system. Do not use yourtractor
battery tostartother vehicles.
TO A'I-rACH JUMPER CABLES -
1. Connect each end of the RED cable to
the POSITIVE (+) terminal of each
battery, taking care not to short
against chassis.
2. Connect one end of the BLACK cable
to the NEGATIVE (-) terminal of fully
charged battery.
3. Connect the other end of the BLACK
cable to good CHASSIS GROUND,
away from fuel tank and battery.
TO REMOVE CABLES, REVERSE ORDER-
1. BLACK cable first from chassis and
then from the fully charged battery.
2. RED cable last from both battedes.
"Positive" =Negative"
(+) (-)
L.H. o
28