Filter
Top Products
CHECK TIRE PRESSURE
The tires on your tractorwere overin-
fiated at the factory for shippingpurposes.
Correcttire pressure is importantfor best
cutting performance.
Reducetire pressureto PSIshown in
"PRODUCTSPECIFICATIONS"section
of this manual.
CHECK DECK LEVELNESS
For bestcutting results,mowerhous-
ing should be properlyleveled. See "TO
LEVELMOWERHOUSING"in the Service
andAdjustmentssection of this manual.
CHECK FOR PROPER POSmTmON
OF ALL BELTS
See the figuresthat areshown for replac-
ing motionand mowerblade drive belts
in the Serviceand Adjustmentssection
of this manual.Verifythat the belts are
routedcorrectly.
CHECK BRAKE SYSTEM
After you learnhow to operateyourtrac-
tor, checkto seethat the brake is properly
adjusted. See "TOADJUSTBRAKE"in
the Serviceand Adjustmentssection of
this manual.
V"CHECKMST
Before you operate and enjoy your new
tractor, we wish to assure that you receive
the best performance and satisfaction
from this Quality Product.
Please review the following checklist:
v" All assembly instructions have been
completed.
v" No remaining loose parts in carton.
v" Battery is properly prepared and
charged. (Minimum 1 hour at 6 amps).
v" Seat is adjusted comfortably and tight-
ened securely.
v" All tires are properly inflated. (For ship-
ping purposes, the tires were overin-
fiated at the factory).
v" Be sure mower deck is properly leveled
side-to-sideifront-to-rear for best cutting
results. (Tires must be properly inflated
for leveling).
v" Check mower and drive belts. Be sure
they are routed properly around pulleys
and inside all belt keepers.
v" Check wiring. See that all connections
are still secure and wires are properly
clamped.
While learning how to use your tractor, pay
extra attention to the following important
items:
v" Engine oil is at proper level.
v" Fuel tank is filled with fresh, clean, regu-
lar unleaded gasoline.
v" Become familiar with all controls - their
location and function. Operate them
before you start the engine.
v" Be sure brake system is in safe oper-
ating condition.