Filter
Top Products
TOATTACH JUMPER CABLES -
• Connect each end of the RED cable to
the POSITIVE (+) terminal of each bat-
tery, taking care not to short against
chassis.
o Connect one end of the BLACK cable to
the NEGATIVE (-) terminal of fully
charged battery.
° Connect the other end of the BLACK
cable to good CHASSIS GROUND,
away from fuel tank and battery.
TO REMOVE CABLES, REVERSE
ORDER -
o Remove BLACK cable first from chassis
and then from the fully charged battery.
o Remove RED cable last from both bat-
teries.
Positive Terminal
Negative Terminal
TO REPLACE HEADLIGHT BULB
o Raise hood,
o Pull bulb holder out of the hole in the
backside of the grill.
, Replace bulb in holder and push bulb
holder securely back into the hole in the
backside of the grill,
o Close hood.
iNTERLOCKS AND RELAYS
Loose or damaged wiring may cause your
tractor to run poorly, stop running, or pre-
vent it from starting,
o Check wiring. See electrical wiring dia-
gram in the Repair Parts section of this
manual.
TO REPLACE FUSE
Replace with 30 amp automotive-type
plug-in fuse. The fuse holder is located
behind the dash.
PositiveTerminal
Battery
Negative Terminal
26