Filter
Top Products
.......... ......:
TO CLEAN BATTERY AND TERMINALS -
Corrosion and dirt on the battery and terminals can cause
the battery to "leak" power,
o Open battery box door,,
o Disconnect BLACK battery cable first then RED bat-
tery cable and remove battery from tractor.,
o Wash battery with solution of four tablespoons of
baking soda to one gallon of water. Be careful not to get
the soda solution into the cells,.
o Rinse the battery with plain water and dry
o Clean terminals and battery cable ends with wire brush
until brighL
o Coat terminals with grease or petroleum jelly,
o Reinstall battery (See "INSTALL BATTERY" in the
Assembly section of this manual).,
V- BELTS
Check V-Belts for deterioration and wear after 100 flours of
operation,, Replace if necessary. The belts are not adjust-
able,, Replace belts if they begin to slip from wear,•
TRANSAXLE COOLING
Keep transaxle free from build-up of dirt and chaff which
can restrict cooling.
ENGINE
LUBRICATION
Only use higl_ quality detergent ol rated with API service
classification SG. Select the oil's SAE viscosity grade
according to your expected operating temperature..
• , ..... ,,, ,,,,,, ,,,....... 1,,,,,,_ ,,:.................... _" '"'_........ : ...........
TO CHANGE ENGINE OIL (See Fig,,18) -
Determine temperature range expected before oil change.
AI oil must meet API service classification SG
Be sure tractor is on level surface,o
o Oil will drain more freelywhen warm.
o Catch oil in a suitable container.
o Remove oil fill dipstick., Be careful not to allow dirt to
enter the engine when changing oil,
o Remove drain plugo
o After oil has drained completely, replace oil drain plug
and tighten securely,.
o Refill engine with oil through oil fill dipstick tube. Pout"
slowly, Do not overfill For approximate capacity see
"PRODUCT SPECIFICATIONS" on page 3 of this
manual,
Use gauge on oil fill dipstick for checking tevelo Be sure
dipstick cap is tightened securely for accurate reading.
Keep oil at "FULL" line on dipstick.
OIL FILL
OIL
DRAIN
PLUG
SAE VISCOSITY GRADES
_F "20_ 0" 30" 32 _ 40" 60_ BO" 100 °
°c -3oo -='0' .1_" 0" fo, _o' _o° no"
TEMPERATURE RANGE ANTICIPATED BEFORE NEXT OIL CHANGE
FIG° '18
NOTE: Although multiviscosity oils (5W30, 10W30 etc)
improve starting in cold weather, these multi-viscosity oils
will result in increased oil consumption when used above
32°F. Check your engine oil level more frequently to avoid
possible engine damage from running tow on oilo
Change the oil after the first two hours of operation and
every 25 hours of operation thereafter or at least once a
year if the tractor is not used for 25 hours in one year,
Check the crankcase oil level before starting the engine
and after each eight (8) hours of operation. Tighten oil fill
cap/dipstick securely each time you check the oil level
FIG, 19
AiR FILTER (See Fig. 20)
Your engine will not run properly using a dirty air filter.
Clean the foam pre-cleaner element after every 25 hours of
operation or every season Service paper cartridge every
100 hours of operation or every season, whichever occurs
first,
Service air cleaner more often under dusty conditions,
o Remove knob(s) and cover,,
TO SERVICE PRE-CLEANER -
o Slide foam pre-cleaner off cartridge,.
o Wash it in liquid detergent and water.
° Squeeze it dry in a clean cloth.
o Saturate it in engine ol Wrap it in clean, absorbent
cloth and squeeze to remove excess oil,
o Reinstall pre-cleaner over cartridge,
• Reinstall cover and secure with knob(s).
17