Filter
Top Products
REWINDING SPOOL
Use .065" diameter ROUND line only. Do
not use heavier gauge line; it will
overload motor and cause overheating.
1. Insert line end about 118"into the
spool hole as shown in Figures 15
and 16.
2. Snugly and evenly wind the line onto
the spool in the direction of the arrow
on the spool until the line builds up to
the notches in the spool rim (Figure
17). Do not overfill spool. The spool
holds about 20 feet of line.
3. Proceed to step 5 of =Spool or Line
Replacement".
INSERTLINEHERE
CLEANING AND STORAGE
Be sure the tool is unplugged.
1. Keep the air intake slots (Figure 18)
clean to avoid overheating.
2. Your trimmer line can dry out oyer
time. To keep your line in top condition,
store spare pre-wound spools or bulk
line in a plastic, sealable bagwith
tablespoon of water.
3. Plastic parts may be cleaned by using
a mild soap and a damp rag.
4. DO NOT immerse tool in water or
squirt it with a hose. DO NOT allow
any liquid to get inside it.
5. Do not store the tool on or adjacent to
fertilizers or chemicals.
6. DO NOT clean with a pressure washer.
7. The line cutter on the edge of the
guard can dull over time. It is
recommended you periodically
touch-up the sharpness of the blade
with a file.
ACCESSORIES
• Replacement spool, Craftsman Model
No. 85680.
• 0,065" diamter ROUND nylon
monofilament trimmer line.
The above accesspry is available at
your local Sears store or Sears service
center.
A,WARNING: The use of any accessory
not sold by Sears for use with this tool
could be hazardous.
IMPORTANT: To assure product
SAFETY AND RELIABILITY, repairs
should be performed by a Sears or other
qualified service facility, using only
identical replacement parts.
Conversion Button
Air Intake Slots
7