Filter
Top Products
i mill I I I I I i1,11|,1, i i
SERVICE AND ADJUSTMENTS
ii ii iiiiiiiii1|111 i iii ii iiiiiiiiiiiii ii
HOW TO REMOVE AN OBJECT FROM THE AIR
INTAKE (Fig. 17 )
If an object is drawn into the unit through the air intake, do
the following:
• Push the switch to the OFF position and disconnectcord
from the power source,
• Remove the vacuum tubes.
Release
Locking Latch
Air Intake/
Vacuum
Inlet Cover
• Locate and remove the object(s).
• Inspect the impeller for cracks, ff cracked or damaged,
DO NOT use the unit. Have impeller replaced by your
Sears Service Center. DO NOT attempt to replace it
yourself. Figure 17
iiiiiiiiiii ii iiii iii IIHIIIIIIIII_I i i ill
STORAGE
ii iiiii ii ii]1 i iiiiiplpl iiiiiiiiii i
immediately prepare your unit for storage at the end of the
season.
STORAGE INSTRUCTIONS
Ifyourblower is to be storedfor a period of time, clean it
thoroughlybefore storage. Remove any dirt, leaves, debris,
etc. Store in a clean dry area.
• Disconnect from the power source,
• Clean the entire unit,
• Open Inlet cover and clean any dirt, grass, or debris that
has collected. Inspect the blower and vacuum tubes.
Close and make sure cover is latched securely.
. Clean air vents and air inletof debris.
• Store your unit in a well ventilated area and covered, if
possible, to prevent dust and dirt accumulation. Do not
cover with plastic. Plastic cannot breathe and wilt induce
condensation and eventual rust or corrosion.
• Do not store cord with objects having sharp edges or cor-
ners. Keep cord away from heated surfaces.
• Store unit and cord unplugged inahigh, cool, dry, indoors
area out of the reach of children.
iiiii i
TROUBLESHOOTING POINTS
I I ii iiiiiiiiiiii i
TROUBLESHOOTING CHART
SYMPTOM
,, , ,,,, ,IL W IJ'
Unit fails to operate. •
Unit vibrates abnormally. •
,i , i,ww i, i
Impeller will not turn freely. •
o
CAUSE REMEDY
, ,,,,,,,, ,, ,,,,,
Switch in the OFF position.
Disconnected from power source.
Circuit breaker tripped, or fuse
blown.
• Mechanical failure.
• Push switch to the ON position.
• Reconnect unit to power source.
• Reset circuit breaker, or replace fuse.
• Contact your Sears Service/Dept,
Hi Hi
Mechanical failure. • Contact your Sears Service/Dept,
i i , i ,,,LL ,,,,,p ,,,v,,,,,,,,, , , i,,,,, ,i
Debds in air intake area. • Clean unit. Remove any debris.
Mechanical failure. • Contact your Sears Service/Dept.
tf situations occur which are not covered in this manual, use care and good judgement.
If you need assistance, contact your Sears Service Center/Department or the
CUSTOMER ASSISTANCE HOTLINE at t-800-235-5878
- 14 -