Craftsman 610.24610 Lawn Mower Accessory User Manual


 
Setting up Lift Mounting Hardware
Tractor Lift can be used out of the box on all Craftsman tractors with bumpers or brush guards. For tractors without bumper or brush guard,
Tractor Lift mounting hardware is provided. Follow the steps below:
Front
6
IlXll
Remove,
add washer ( 24 ),
replace.
Rear
31
32
6
Remove existing bolt "X" and set aside. If tractor does not
have this bolt, use supplied 3/8" x 1-1/4" bolt and 3/8" nyloc nut.
Insert bolt ( 29 ) through inside front hole of frame, through
tractor bracket ( 7 ) and secure with nyloc nut ( 27 ).
Add flat washer ( 24 ) under head of bolt removed in earlier
step and reinsert through tractor mounting bar and tighten.
For LT1000 & LT2000 series tractors, use self-thread bolts
( 28 ) in place of bolt ( 29 ) and nut ( 27 ).
Slide lifting bar ( 6 ) through cut-out in tractor brackets.
Pin lifting bar in place with one hairpin cotter ( 26 ) on each
side, inside of tractor brackets ( 7 ).
Place lifting bar ( 6 ) under rear tractor hitch and slide threaded
stud through hole.
Secure in place with flat washer ( 32 ) and hex nut ( 31 ).
FOR MISSING PARTS, Call 1-800-652-2321, Monday - Friday, 8 a.m.- 5 p.m.E.S.T.
Page 5.