Filter
Top Products
TROUBLE
Difficult starting
,, ,CAUSE . ..... • CORRECT!ON .................................................
Defective spark plug Replace defective plug
Water or dirt in fuel system
,, , ,,, , , ,, ,, , ,, ,,,
Blocked fuel line or low on fuel
Engine runs er-
ratically
Engine stalls
Engine runs er-
ratically;
or
Loss of power
Excessive
vibration
Units fails to
propel itself
iUnit fails to
discharge snow
Unit running on CHOKE
Water or dirt in fuel system
Loose parts; damaged impeller
Drive belt loose or damaged
Incorrect adjustment of auger con-
trol cable
Wom or damaged friction wheel
Auger drive belt loose or dam-
aged
Auger control cable not adjusted
correctly
Use carburetor bowl drain to
flush and refill with fresh fuel
....... ,, ,, ,,,,,,,, ,, , , ,
Clean fuel line; check fuel sup-
ply; add fresh gasoline (gaso-
line/oil mixture if 2-cycle engine)
Move choke lever to OFF position
Use carburetor bov¢l drain t0 ......
flush and refill with fresh fuel
Stop engine immediately and
disconnect spark plug wire.
Tighten all bolts and make all
necessary repairs. If vibration
continues, have the unit ser-
viced by a Craftsman service
repairman
Replace drive belt
Adjust traction drive cable
Repair friction wheel
Replace auger belt
Adjust auger control cable
Replace with shear pin located
in tool box on belt cover,
Stop engine immediately and
disconnect spark plug wire,
Clean discharge chute and in-
side of auger housing,
Stop engine immediately and dis-
connect spark plug wirer Remove
object from auger.
Shear bolt broken
Discharge chute clogged
Foreign object lodged in auger
23