Filter
Top Products
ASSEMBLY
i i iiiii lUU i iiiillU, UUl i i ii ii iiill
TO iNSTALL CHUTE ASSEMBLY TO
CHUTE FLANGE
Q Remove the chute assembly from the carton
• _Usinga 1/2 inch wrench or adjustable wrench, re-
move the three (3) nuts, Iockwashers, flatwashers
and carriage bolts from the chute flange°
® PPlacethe chute assembly over the outside of the
_chute flange so that the "A" on the chute assembly
is next to the "A" on the chute flange This will al+gn
' al!three holes correctly+
• _.Fromthe inside of the chute flange, insert the three
[(3) carriage bolts (removed earlier) through the
\
ithree square holes The square part of the carnage
bolls should fit into the square holes in the chute
+!lange+
® .lnstall the three (3) flatwashers, !ockwashers and
'nuts (removed earlier) on the carriage bolts.
t
:._ ,Juu.ltl
CAUTION: IFALL THE THREE (3) CARRIAGE
'_ BOLTSCANNOT BE MOUNTED,THE HOLES
ARE NOTALIGNED CORRECTLY.CHECK THE
POSITION OFTHE LETTER"A's" ONTHE
CH_JTEASSEMBLYAND CHU_ FLANGE. THEY MUST
BENEXT TO EACHOTHER+IFLESS THAN THREE (3)
HOLES LINE UP,YOU HAVEMOUNTED THE CHUTE AS-
SEMBLYINCORRECTt.YAND SNOW COULDBE DIS-
CHARGED TOWARDTHE OPERATOR.RE+INSTALLTHE
CHUTE ASSEMBLYIFNECESSARY.
NUT
LOCKWASHER
FLATWASHER
CARRIAGE
BOLT
(SHOWN
CHUTt
A
FIG. 8
CHUTE
ASSEMBLY
SQUARE
HOLE IN
CHUTE FLANGE
t
<
10