Craftsman 536.7974 Edger User Manual


 
CUSTOMER RESPONSIBILITIES
SERVICE
RECORDS
SCHEDULE
Fill In dates as After Before Fre- E_ew Every Every Begin Before
you complete First Each quently i 10 25 Each StoragG
regular service 2 Use Hours Hours Hours Season
Hours
SERVICE
DATES
Lubricate aJtPivot Points _ IJ
Lubricate Wheel Axles t,/
Check Engine Oil Level t.J ......
Change Engine Oil _ ._ ;_.. _:_: V_
Replace Air Cleaner Filter I_
Check Spark Plug I............ p1 p1
Check Drive Belt p'#
Tighten All Screws and Nuts p_
Check Blade Wear/Damage _ .... ivf ......
Lubricate Quill Rod/Tube 1_' [ , PJ P_
PRODUCT SPECIFICATIONS
HORSE POWER: 4
DISPLACEMENT: 9.06 cu. in. (148 cc)
GASOLINE CAPACITY. 1.25 qt. :_,, :,
(unleaded regular)
LUBRICATION:
SPARK PLUG:
(Gap .030)
20 oz. SAE-30W
Champion RJ19LM
or Equivalent
NOTE: If the Edger is being used in sandy
or dusty areas, change the oil more fre-
quently to prevent premature engine wear.
TO CHANGE ENGINE OIL
Disconnect the spark plug wire from the
spark plug.
*_ Remove the oil drain plug as shown in
first figure on page 12 and drain the oil
into a flat pan.
_ After draining all the oil, reinstall the oil
drain plug securely.
GENERAL RECOMMENDATIONS
The warranty on this Edger does not cover
items that have been subjected to operator
abuse or negligence. To receive full value "
from the warranty, the operator must main-
tain the Edger as instructed in this manual.
The above chart is provided to assist the
operator in properly maintaining the Edger.
NOTE: The oil will drain more freely when
the engine is warm.
Remove the oil fill cap/dipstick. See first
figure on page 9.
Fill the engine crankcase, pouring slowly.
DO NOT OVERFILL. For approximate ca-
pacity see PRODUCT SPECIFICA-
TIONS on this page.
LUBRICATION
After each 25 hours of use of your Edger,
apply light machine oil to all moving
parts, particularly the wheels.
We recommend that the oil in the engine
crankcase be changed after the first
2 hours of operation and after each 25
hours of use thereafter.
NOTE: The quill assembly bearings are
factory sealed and will require no lubrica-
tion.
Reconnect the spark plug wire on the
spark plug.
11
7