Filter
Top Products
CAUTION: DO NOT ASSEMBLE WITH
POWER RAKE PLUGGED iNTO A
POWER SOURCE
STEP 3: (SEE FIGURE 3)
, Turn the Power Rake housing upright and attach the
long end of each of the middle handle tubes to the
lower handle tube using two carriage bolts (C) and
wing knobs (D).
STEP 1:
e
e
(SEE FIGURE 1)
Turn the Power Rake housing upside down.
Fasten the end of the lower handle tube with air
intake holes to the side of the Power Rake housing
with the large hole. Use the right handle bracket (H),
hex bolt (A), right handle clamp (J) and wing knob
(D). Align the pin in the bracket with the slot in the
housing and tighten the wing knob.
AIR INTAKE HOLES
SLOT
LARGE HOLE
SHORT END
\
/
LONG END
c
FIGURE 3
FIGURE 1
STEP 2: (SEE FIGURE 2)
• Fasten the lower handle tube to the left side of the
Power Rake housing. Use the left handle bracket (I),
carriage bolt (B), left handle clamp (G) and wing knob
(D). Align the pin in the bracket with the slot in the
housing and tighten the wing knob
SLOT
I
STEP 4: (SEE FIGURE 4)
Slide the power cord holder (F) onto the right middle
handle tube.
F
FIGURE 2
4
FIGURE 4
Call 1-866-576-8388 for missing parts or assembly help
DO NOT RETURN TO STORE