Filter
Top Products
STEP 2: (SEE FIGURE 3)
* Remove tractor hood. (Refer to tractor manual.)
* Remove the browning shield as shown.
REMOVE
FRONT SCREWS
REMOVE
BROWNING SHIELD
FIGURE 3
STEP 3: (SEE FIGURE 4)
* Place plug on a work bench or solid table and push
end of bumper down onto plug. Repeat for all plugs.
BUMPER
-._
PUSH DOWN
WiTH EVEN
PRESSURE
WORK BENCH
OR SOLID TABLE
STEP 4: (SEE FIGURE 5)
* Insert a carriage bolt into the second mounting hole
from the front of the tractor frame and fully tighten a
whizlock nut onto the bolt. Repeat on other side of
tractor.
CARRIAGE BOLT
AND WASHER
\
WHIZLOCK
NUT
FIGURE 5
STEP 5: (SEE FIGURE 6)
* Spread ends of bumper enough to fit slots onto bolts
in rear mounting holes in tractor frame.
* The bumper has three mounting holes. The rear
hole provides the most clearance while the forward
holes provide a neater appearance. Use a hole
that provides enough clearance for hood to stay in
raised position when opened. Insert a carriage bolt
and washer through tractor frame and into desired
mounting hole on each side of bumper and secure
with a whizlock nut.
IMPORTANT: Before fully tightening nuts, be sure
tractor hood will stay in raised position when opened.
CARRIAGE BOLT
AND WASHER
FIGURE 6
4 Call 1-866-576-8388 for missing parts or assembly help
DO NOT RETURN TO STORE