Filter
Top Products
DUAL ROD DECK SUSPENSION TRACTORS
IMPORTANT: Thoso instructions are for tractors with dual
mower deck suspension brackets like the examples shown
in figure 2 on this page.
CAUTION! Muffler is hot! Allow engine to
cool down before proceeding with bumper
installation.
STEP 1: (SEE FIGURE 1)
• Remove tractor hood. (Refer to tractor manual.)
• Remove an (LT) Lawn Tractor heat shield like the one
shown. Remove a (GT) Garden Tractor heat shield
like the one shown only if you need access to inside
of tractor frame during step 2.
iMPORTANT: Be sure to re-attach the heat shield after
bumper is installed.
(LT) LAWN TRACTOR
-1 REMOVE THIS
STYLE HEAT SHIELD
(GT) GARDEN TRACTOR
REMOVETHIS HEAT SHIELD
ONLY IF MUFFLER MUST BE
IN STEP 2
FIGURE 1
STEP 2: (SEE FIGURE 2)
• Remove any bolts present in front mounting holes in
side of tractor frame. If bolt will not screw out of hole,
check if a nut is present on bolt on inside of frame.
On GT tractors, if access to nut is blocked by a front
mounted muffler, slide muffler down exhaust tubes to
rest on top of browning shield.
iMPORTANT: Be sure to re-attach muffler and heat
shield after bumper is installed.
• If rear mounting holes in tractor frame are empty,
install hex bolts (C) and hex nuts (D) supplied in parts
bag. See figure 2.
(LT) LAWN TRACTOR
REMOVE BOLT INSTALL(C), (D)IF
=_ii_I-_-_--_ IF PRESENT HOLE IS EMPTY
\
SUSPENSION BRACKET
(LT) LAWN TRACTOR
REMOVE BOLT INSTALL (C), (D) IF
HOLE IS EMPTY
SUSPENSION
BRACKET
(GT) GARDEN TRACTOR
EXHAUST TUBES
BROWNING SHIELD J
SUSPENSION BRACKET
FIGURE 2
REMOVE BOLT
IF PRESENT