7
INSTALL THE WIRE HARNESS AND THE
ON/OFF SWITCH
• Slide the Wire Harness under the Cable Anchor of
the Hitch Assembly.
• Connect two 1/4 Female Spade Connectors from
the Wire Harness to the prongs of the ON/OFF
Switch.
• Insert the Seat Switch Plug of the Wire Harness into
the Hitch Assembly, Pulling it up and through the
right top side of the Switch Mounting Bracket.
• Remove one Ring Nut from the ON/OFF Switch and
adjust the second Ring Nut 1/4 Inch from the top of
the threads.
• Insert the ON/OFF Switch up through the Switch
Mounting Bracket and secure it by reinstalling the
Ring Nut.
NOTE: The notch in the threads of the ON/OFF Switch
must face toward the "ON" of the ON/OFF Switch Decal
to insure proper ON/OFF control.
FIG. 1