Filter
Top Products
STEP 10: (SEE FIGURE 10)
, Raise the tractor's hood.
, insert the ends of the front brace rod into the inner set
of holes in the U-tube and rest the bottom of the brace
rod on the dash pane!. If the brace rod is too long to
rest on the dash panel, you can shorten the overall
length of the rod by inserting the upper ends of the
rod into one of the wider spaced sets of holes.
RAISE HOOD
FRONT BRAOE ROD
FIGURE 10
STEP 11: (SEE FIGURE 11)
, With the tractor's hood still raised, place the snow cab
canopy onto the tubing frame and drape the front flap
down in front of the tractor% dash panel. Lower the
hood, trapping the front flap under the hood. Secure
the sides of the canopy by fastening the elastic hooks
to the bottom edge of the footrest and fender. Tie the
straps at back of canopy to the upright tubes. Any
levers or handles on snow throwers or snow blades
should be located outside of the cab.
LOWER
HOOD
/
FRONT FLAP
/ ELASTIC HOOK
t
FIGURE 11