Craftsman 358.799400 Blower User Manual


 
STOPPING YOUR UNIT
Slide the ON/OFF switch to the OFF
_£1.Asition.
RTING YOUR UNIT
Your unit has two run positions, LOW
and HIGH. Slide the switch to one of
these positions to turn on the unit.
_iIkWARNING: Do not use the unit
without the tubes or collection bag
properly attached to avoid flying debris
and/or impeller contact which can
cause serious injury. Always wear eye
protection to prevent rocks or debris
from being blown or ricocheting into
the eyes and face which can result in
blindness or serious injury.
OPERATING POSITION
Eye Protection Eye Protection
r Vacuum
USING YOUR UNIT AS A BLOWER
4_.I!bWARNING: Inspect the area be-
fore using the unit. Remove all debris
and hard objects such as rocks, glass,
wire, etc., that can ricochet, be thrown,
or otherwise cause injury or damage
during operation.
Use your unit as a blower for:
Sweeping debris or grass clippings
from driveways, sidewalks, patios, etc.
Blowing grass clippings, straw, or
leaves into piles, or removing debris
from corners, around joints, or be-
tween bricks.
Direct air flow by directing the blower
tube down or to one side. Always work
away from solid ob ects such as walks,
large stones, vehicles, and fences.
Clean corners by starting in corners and
moving outward. This will help prevent
an accumulation of debris which could
fly into your face.
Be careful when working near plants.
The force of the air could damage
tender plants.
USING YOUR UNIT AS A VACUUM
_lk WARNING: Do not vacuum
stones, gravel, metal, broken glass,
etc., to avoid severe damage to the im-
peller. To avoid the possibility of elec-
trical shock, do not attempt to vacuum
water or other liquids.
Use your unit as a vacuum to pick up
dry material such as leaves, grass,
small twigs, and bits of paper.
For best results during vacuum use,
operate your unit at high speed.
Move slowly back and forth over the
material as you vacuum. Avoid forc-
ing the unit into a pile of debris as
this can clog the unit.
Keep the vacuum tube about an inch
above the ground for best results.
_WARNING: If the unit becomes
clogged, stop the unit and unplug the
extension cord. Wait until the impeller
has completely stopped turning, then
remove the vacuum tubes. Carefully
reach into the vacuum opening and
clear out the clogged debris.
CUSTOMER RESPONSIBILITIES
WARNING: Disconnect power source before performing maintenance.
CARE & MAINTENANCE TASK
Check for loose fasteners and parts
Check for damaged or worn parts
Inspect and clean unit and labels
Remove and empty collection bag
Clean collection bag
WHEN TO PERFORM
Before each use
Before each use
After each use
After each use
Yearly
9