Craftsman 358.794941 Blower User Manual


 
3. Remove the vacuum bag.
4= Close the vacuum inlet cover and
make sure it is latched closed.
5= Reinstallthe blowertube (see
BLOWER TUBE ASSEMBLY).
SHOULDER STRAP ADJUSTMENT
(for vacuum use only)
1. Hold the unit as shown with the
muffler side facing away from your
body and clothes.
2= Pass the shoulder strap over your
head and onto your right shoulder.
3. Extend your left arm toward the
rear of the vacuum bag.
4. Adjust shoulder strap until the vac-
uum bag/shoulder strap seam lies
between your thumb and index
finger.
5. Make sure air flows freely from the
elbow tube into bag. If bag is kinked,
the unit will not operate properly.
KNOW YOUR BLOWER
READ THIS iNSTRUCTiON MANUAL AND SAFETY RULES BEFORE OPERATING YOUR
UNIT. Compare the illustrations with your unit to familiarize yourself with the location
of the various controls and adjustments. Save this manual for future reference.
Upper
Lower Vacuum T_
Vacuum Tube
Elbow Tube
Blower
Tube
Throttle
Lever
Primer Button
Choke Lever
Fuel Mix
Fill Cap
Starter
Rope
Rear
Handle
THROTTLE LEVER
The THROTI-LE LEVER is used to select
the desired engine speed and to stop the
engine. Move the throttle lever to the
'{_ position for full speed operation.
Move the throttle lever to the _ posi-
tion for idle speed. To stop the engine,
move the throttle lever to the STOP posi-
tion.
PRIMER BUTTON
The PRIMER BUqq-ONremoves air from
the carburetor and fuel lines and fills
them with fuel. This allows you to start
the engine with fewer pulls on the starter
rope. Activate primer button by pressing
it and allowing it to return to its original
position.
-6-