Filter
Top Products
CARTON CONTENTS
Check carton contents against the fol-
lowinglist,
Model 358.792430
• Brushcutter Attachment
• Handlebar (with Clamp and Knob)
• Handlebar Clamp Base (with Spacer
Tabs)
• Shoulder Strap
• Upper Shoulder Strap Clamp
• Lower Shoulder Strap Clamp (with
Spacer Tabs)
• Handlebar Clamp Screws (4)
• Shoulder Strap Clamp Screws (2)
• Attachment Hanger
• Hex Wrench
Examine parts for damage. Do not use
damaged parts.
NOTE: If you need assistance or find
that parts are missing or damaged, call
1-800-235-5878.
ASSEMBLY
z't
tl WARNING: If received assembled,
repeat all steps to ensure your unit is
properly assembled and all fasteners
are secure.
• A hex wrench (provided) is required
for assembly.
INSTALLING BRUSHCUTTER AT-
TACHMENT
CAUTION: When removing or instal-
ling attachments, place the unit on a
flat surface for stability,
1. Loosen the coupler by turning the
knob counterclockwise.
Coupler
LOOSEN
TIGHTEN Knob
2. Remove the tube cap from the
brushcutter attachment (if present).
3. Position locking/release button of
attachment into guide recess of
coupler.
4. Push the attachment into the cou-
pler until the locking/release button
snaps into the primary hole,
5. Before using the unit, tighten the
knob securely by turning clock-
wise.
Coupler Primary Hole
\ /_uide Recess
Upper Locking/ Lower
Tube Release Attachment
Button
_11_WARNING: Make sure the lock-
ing/release button is locked in the pri-
mary hole and the knob is securely
tightened before operating the unit.
HANDLEBAR ASSEMBLY
DANGER: RISK OF CUT. To
avoid serious injury, the barrier portion of
the handlebar must be installed as
shown on the upper tube of the power-
head to provide a barrier between op-
erator and the spinning blade. Attach
tube clamp above arrow on safety warn-
ing decal on the upper tube (powerhead
end of unit). Ensure handlebar is posi-
tioned on handlebar clamp between the
arrows on the handlebar decal.
NOTE: The tube clamp base has four
spacer tabs attached, These tabs are
provided to adapt this attachment for
use with powerheads that have a 1" di-
ameter upper tube (the tube clamp will
not tighten down securely on the 1" di-
ameter upper tube without using these
spacer tabs). The tabs must be broken
off completely before use and placed
over the screw holes on the clamp base.
These tabs are not needed for power-
heads with a 7/8" upper tube.
HANDLEBAR CLAMP BASE
Spacer T_ _lb_
Spacer Tabs _
posi!ioned for use _ _
on 1 diameter __p.,,'__
upper tube _U
1. Place the tube clamp over the up-
per tube above the arrow on the
safety decal.
2. Position the clamp base under the
upper tube and align the tube
5