Filter
Top Products
2. Loosenandremovebarknobcom-
pletelybyliftingteverandturning
counterclockwise,
CRRF
LOOSEN
3. Loosen chain tension by turning
adjusting wheel (upward direction),
Remove clutch cover.
\
Bar
Knob
4. Slide guide bar on bar bolts until
guide bar stops against clutch
drum sprocket.
Guide bar
Bar bolts
5. Remove the old chain.
6. Carefully remove the chain from the
package. Hold chain with the drive
links as shown.
Drive Links
7. Place chain over and behind clutch
retainer, fitting the drive links in the
clutch drum sprocket.
8. Fit bottom of drive links between
the teeth in the sprocket in the
nose of the guide bar.
9. Fit chain drive links into bar groove.
10. Putt guide bar forward until chain is
snug in guide bar groove. Ensure
all drive links are in the bar groove.
11. install clutch coven Be sure adjust-
ing pin is in the adjusting pin hole
in the guide bar,
CAUTION: tt is very important when
installing the clutch cover that the adjust-
ing pin aligns into the adjusting pin hole
in the bar. Failure to install the clutch
cover correctly may result in permanent
damage to your chain saw.
B_ck
view of
clutch
cove[
Adjusting
12. install bar knob and finger tighten
only. Do not tighten any further at
this point. Proceed to CHAIN AD-
JUSTMENT.
CHAIN ADJUSTMENT
See CHECK CHAIN TENSION in MAINTE-
NANCE section.
CARBURETOR ADJUSTMENT
,_. WARNING: The chain wilt be
moving during most of this procedure.
Wear your protective equipment and
observe all safety precautions. The
chain must not move at idle speed.
The carburetor has been carefully set
at the factory. Adjustments may be
necessary if you notice any of the fol-
lowing conditions:
• Chain moves at idle. See IDLE
SPEED-T adjusting procedure.
• Saw witt not idle. See iDLE SPEED-T
adjusting procedure.
DHRECTtONOF ROTATION
19