Filter
Top Products
5
Cutting Attachment
Shield
Fuel Cap
Throttle
Control
D-Handle
HassleFree™
Shaft Grip
Primer Bulb
Oil Fill Plug
Choke Lever
Shaft
Housing
Starter Rope
Grip
Muffler
Twist & Edge and
Craftsman
Convertible™ Coupler
On/Off Stop
Control
Air Filter Cover
INSTALLING AND ADJUSTING THE D-HANDLE
1. Remove the screws and bottom clamp piece that were
installed on the D-handle for shipping.
2. Place D-handle the over the shaft housing and onto the
bottom clamp (Fig. 1). Place it a minimum of 6 inches
(15.24 cm) from the end of the shaft grip.
3. Start screws with a large Flat-head or T-25 Torx
screwdriver. Do not tighten until you make the handle
adjustment.
4. If the D-handle was pre-installed, loosen the screws on the
handle just enough to move it.
5. While holding the unit in the operating position (Fig. 13),
position the D-handle to the location that provides you the
best grip.
Fig. 1
(4) Screws
Shaft Grip
Shaft
Housing
On/Off Stop Control
Minimum 6 Inches
(15.24 cm)
D-Handle
Bottom Clamp
Spark
Plug
KNOW YOUR UNIT
ASSEMBLY INSTRUCTIONS
6. Tighten the clamp screws evenly, until the D-handle is
secure.
INSTALL LINE TRIMMER ATTACHMENT
NOTE: To make installation easier,
place the unit on the
ground or on a workbench.
1. Turn knob counterclockwise to
loosen coupler (Fig. 15, p. 8).
2. While firmly holding attachment,
push it straight into the coupler
until the release button snaps
into the primary hole (Fig. 16, p.
9).
NOTE: Aligning the release button
with the guide recess (Fig.
16, p. 9) will help
installation.
3. Turn the knob clockwise to
tighten.
LINE TRIMMER APPLICATIONS
Cutting grass and light weeds; edging; and decorative trimming
around trees, fences, etc.
Fig. 2
Line
Cutting
Blade