Filter
Top Products
Gear Housing
Drive Shaft
Assembly
indexing Ring
Adjustment Bolt
Blade
Hanger
Angle
Adjustment
Handle
WARNING: DO NOT USE an extension boom with
this product. It is not designed to be used with an
extension and using one may cause serious injury.
iNSTALLiNG / REMOVING THE ATTACHMENT
WARNING: Read and understand operator's manual
I for unit to be used with this attachment prior to
operation.
_ I WARNING: To avoid serious personal injury and
damage to the unit, shut unit off before removing or
installing attachments.
I
Installing the attachment:
NOTE: To make installing or removing the attachment easier, place
the unit on the ground or on a work bench.
1. Remove the hanger from the top of the shaft housing.
2. Turn knob counterclockwise to loosen (Fig. 1).
Craftsman Convertible TM Release Button
Primary Hole
\
Upper Shaft v/1 _ v Lower Shaft
Housing Knob _ Housing
Fig. 2
J
Craftsman Convertible TM
Coupler Release Button Guide Recess
Loosen
Tighten L
Knob
Fig. 3
Fig. I
3. While firmly holding the attachment, push it straight into the coupler
until the release button snaps firmly into the primary hole (Fig. 2).
NOTE: Aligning the release button with the guide recess will help
installation (Fig. 3).
4. Turn the knob clockwise to tighten (Fig. 1).
CAUTION: The attachments with the coupler system
are to be used in the primary hole only. Using the wrong
hole could lead to personal injury or damage to the unit.
l CAUTION: Lock the release button in the primary
hole (Fig. 2) and securely tighten the knob before
operating this unit.