Filter
Top Products
TROUBLE SHOOTING GUIDE
Trouble Correctlve Action
Does not start
Engage motorlblede control.
Be sure that the extension cord is plugged
into the outlet and the lawn mower
switch plug.
Check to see if a fuse has been blown or
a circuit breaker tripped in your
electrical box.
Replace motorlblade control switch.
Possible Cause(s)
1. Motor/blade control disengaged. 1.
2. Extension cord disconnected. 2.
3. Blown fuse or a tripped circuit breaker. 3.
4. Motorlblade control switch defective. 4.
1. Cutting too much grass. 1.
2. Circuit overloaded. 2.
1. Cutting toe much grass. 1.
2. Build-up of grass, leaves and debris under 2.
mower.
1. Worn, bent or loose blade. 1.
2. Build-up of grass, leaves and debris under 2.
mower.
1. Worn, bent or loose blade. 1.
2. Bent motor shaft. 2.
1. High grass or cutting height toe low. 1.
2. Rear of mower housing and blade dragging 2.
in heavy grass.
Frequent blowing of fuses Set in "Higher Cut" position.
Do not use a higher rated fuse without
consulting your power company.
If condition persists (be sure circuit is not
overloaded), have your unit checked by
your nearest Authorized Sears Service
Dealer.
Loss of power Set in "Higher Cut" position.
Disconnect power cord and clean underside
of mower housing.
Poor or uneven cut Replace blade. Tighten blade nut.
Disconnect power cord and clean underside
of mower housing.
Too much vibration Replace blade. Tighten blade nut.
Contact Sears Service Department.
Hard to push Raise cutting height
Raise cutting height.
Note: For repairs beyond the minor adjustments listed above, contact your nearest SEARS Service Center.
The use of any accessory on this Rotary Mower other than those manufactured by the mower manufacturer is not
recommended.
_b WARNING: DO NOT operate the mower without the entire grass catcher or chute deflector in place.
DO NOT operate the mower without the protective shield on the rear of the deck In place.
12