Filter
Top Products
Figure4
2.Pullthepowerhandleandtool
attachmentapart.Thepowerhandle
andtoolattachmentshouldseparate
easily.Iftheydonot,checktobe
surethatthelockringisinthefully
unlockedposition.
AttachingtheBattery
1.Aligntheribonthebatterypackwith
thecorrespondingslotintheendofthe
powerhandle.(seefigure5)
I
0
Figure 6
2. Pull the battery pack straight out
from the handle.
To turn the tool on:
1. Grip the control grip firmly with one
hand and grip the auxiliary handle on
the tool attachment (if provided) with
the other hand.
2. Push the switch that your thumb
rests on straight forward; this is the
safety release. (see figure 7)
Figure 5
2. Insert the battery fully into the
handle making sure that the spring-
loaded buttons on each side of the
battery pack snap into place in the
handle.
Removing the Battery
1. Depress the spring-loaded
buttons on both sides of the battery
simultaneously. (see figure 6)
Figure 7
3. While holding the switch under your
thumb in the forward position, use your
fingers to pull upward on the control
trigger. (see figure 8) This will energize
the tool and allow you to do your work.
It is NOT necessary to keep pressure
on the thumb switch after the tool has
started.
Please note that the tool will not start
if the lock ring is not in the fully locked
position.