Filter
Top Products
4
SAFETY
Machine preparation
- Check operator presence interlock system and
brake operation. Adjust or repair any problems
before using.
- Do not tamper with or defeat safety devices.
Keep guards, shields and interlock safety devices
in place and in proper working condition. They
are for your protection.
- Keep all fasteners such as nuts, bolts and pins
well secured.
- Visually inspect blades, blade bolts and the cutter
assembly for wear or damage. Replace worn or
damaged blades and bolts to preserve balance.
- Verify that machine and attachments, if any, are
in good operating condition.
- Do not engage blades until ready to mow.
OPERATING SAFELY
In general
- Use extra care when loading or unloading the
machine into a trailer or truck.
- Slow down and use caution when making turns
and crossing roads and sidewalks. Stop blades if
not mowing.
- Do not run the engine in an enclosed area where
dangerous carbon monoxide fumes can collect.
- Do not place your foot on the ground while
operating the machine.
- Before operating, lower the discharge chute,
install the mulcher or put the entire grass catcher
in place.
- Keep clear of the discharge opening at all times.
Never direct the discharge toward a bystander.
Stop operation if someone approaches.
- Keep washout ports and other mower housing
service openings closed when mowing.
- Use care when pulling loads or using heavy
equipment.
- Use only approved draw bar hitch points.
- Limit loads to those you can safely control.
- Do not turn sharply. Use care when reversing.
- Use counter-weight(s) or wheel weights when
suggested in the operator's manual.
- Never leave a machine unattended. Always turn
off blades, set parking brake, stop engine and
remove key before dismounting.