Filter
Top Products
19
ADVANCED DRIVING
Executing an End-Of-Row Zero
Turn
Your zero turn rider’s unique ability to turn in
place allows you to turn around at the end of
a cutting row rather than having to stop and
make a Y-turn before starting a new row.
For example, to execute a right end-of row
zero turn:
1. Slow down at the end of the row.
2. Move the LEFT ground speed control
lever forward slightly while moving the
RIGHT ground speed control lever back to
center and then slightly back from center
(see Figure 12). Be sure to keep both
wheels moving to avoid turf damage.
3. Begin mowing forward again.
This technique turns the rider RIGHT and
slightly overlaps the row just cut - eliminating
the need to back up and re-cut missed grass.
As you become more familiar and experi-
enced with operating the zero turn rider, you
will learn more maneuvers that will make your
mowing time easier and more enjoyable.
Remember, the more you practice, the bet-
ter your control of the rider will be!
Practice Turning Around a Corner
While traveling forward allow one handle to gradually
return back toward neutral (see Figure 10). Practice sev-
eral times before mowing.
NOTE: To prevent damaging your lawn by pivoting direct-
ly on the tire tread, it is best to keep both wheels going at
least slightly forward.
Executing Turns
Figure 10. Right Turn
Figure 11. Turning in Place
Turning In Place
Figure 12. Executing an End-Of-Row Turn
Practice Turning In Place
To “zero turn” means to turn in place. To turn in place,
gradually move one ground speed control lever forward
from neutral and one lever back from neutral simultane-
ously (see Figure 11). Repeat several times.
Not for
Reproduction