Filter
Top Products
These instructions do not claim to cover all details or variations in the equipment, procedure, or process described, nor to provide directions for meeting every possible
contingency during installation, operation or maintenance. When additional information is desired to satisfy a problem not covered sufficiently for user’s purpose, please
contact your nearest representative.
4. Attach Arm to Pole -
Slide the NUT PLATE into the POLE. Install the THREADED RODS through the holes in the
POLE and into the NUT PLATE. Slide the ARM over the THREADED RODS. See Figure 4.
NOTE: Use of a thread locking compound (not supplied) is suggested where the THREADED
RODS contact the NUT PLATE.
5. Attach Housing to Arm -
Remove the WIREWAY PLUG from the HOUSING. Move the fixture leads aside so the THREADED RODS may be accessed
through the fixture HOUSING. See Figure 5a.
Feed the fixture wires through the ARM. Slide the HOUSING over the THREADED RODS and secure it with the PLAIN WASHERS,
LOCK WASHERS and HEX NUTS. Torque HEX NUTS as follows:
Medium Icon (ICM) - 450 in-lbs., Small Icon (ICS) - 130 in-lbs. See Figure 5b.
NOTE: It may be helpful to use a deep socket
when installing the HEX NUTS.
Re-install the WIREWAY PLUG into
the wireway in the HOUSING.
Customer First Center • 1121 Hwy 74 South • Peachtree City, GA 30269 IMI-593 AVU040206
Pole Mounted Icon
Sheet 3 of 5
3/11/04 IMI-593
INSTALLATION INSTRUCTIONS
IMPORTANT: READ CAREFULLY BEFORE INSTALLING FIXTURE.
RETAIN FOR FUTURE REFERENCE.
TM
WARNING: Risk of Electric Shock. Disconnect power at fuse or circuit breaker before installing
or servicing.
Pole
Arm
Rods
Nut Plate
WARNING
Risk of Personal Injury
Fixture may become damaged and/or
unstable if not installed properly
Tighten all fixture components to their
recommended torque values
Fig. 4
Wireway Plug
Fig. 5a