Filter
Top Products
5
Assembly
continued.
Step 3 (continued) Step 4 (continued)
Step 4
■ Set cylinder cover assembly on
top of heater base. Position opening
opposite the wheels.
■ Tighten all fasteners. Use a #2
Phillips screwdriver to tighten all
screws. Use a 7/16" open end
wrench to tighten all hex nuts.
Step 5
■ Attach three Support Brackets to Base with three large screws down-
ward through Support Brackets into the Base.
■ Attach one large screw loosely
at base of the second Side
Support Bracket.
■ Attach the second Side Support
Bracket loosely with Hex Nut at
top.
1 Required
Large Screw
2 Required
Large Screw
3 Required
Large Screw
1 Req’d
Hex Nut
■ Attach Cylinder Cover Pieces to Base with two large screws horizon-
tally into the Base Tabs.