Chauvet MIST-PS8 Landscape Lighting User Manual


 
COLORmist System User Manual 3 2005-10-10/18:36
MI
ST
-
PS8 AC Voltage Switch
BEFORE YOU BEGIN
COLORmist System
Your COLORmist LED color system may include either of the two packages listed;
SYS-PAR4, PAR Pack System SYS-PANEL2, Panel Pack System
1 x MIST-CON, Controller 1 x MIST-CON, Controller
4 x MIST-PAR80, Par Can 2 x MIST-PANEL, Panel
1 x MIST-PS8, Power Unit 1 x MIST-PS8, Power Unit
1 x MIST-CBL33, Power/Signal Cable 33 1 x MIST-CBL33, Power/Signal Cable 33
4 x MIST-CBL5, Power/Signal Cable 5 2 x MIST-CBL5, Power/Signal Cable 5
User Manual & Warranty Card User Manual & Warranty Card
Unpacking Instructions
Immediately upon receiving a product, carefully unpack the carton, check the contents to ensure that
all parts are present, and have been received in good condition. Notify the shipper immediately and
retain packing material for inspection if any parts appear damaged from shipping or the carton itself
shows signs of mishandling. Save the carton and all packing materials. In the event that a fixture
must be returned to the factory, it is important that the fixture be returned in the original factory box
and packing.
AC Power
To determine the power requirements for a particular product, see the label affixed to the back plate
of the product or refer to the products specifications chart. A products listed current rating is its
average current draw under normal conditions. All fixtures must be powered directly off a switched
circuit and cannot be run off a rheostat (variable resistor) or dimmer circuit, even if the rheostat or
dimmer channel is used solely for a 0% to 100% switch. Before applying
power, check that the source voltage matches the products requirement.
Check the product or device carefully to make sure that if a voltage selection
switch exists that it is set to the correct line voltage you will use.
Warning! If applicable, verify that the power select switch on your unit matches the line
voltage applied. All fixtures must be connected to circuits with a suitable Earth
Ground.
Safety Instructions
Please keep this User Guide for future consultation. If you
sell the unit to another user, be sure that they also receive
this instruction booklet.
Always make sure that you are connecting to the proper
voltage and that the line voltage you are connecting to is
not higher than that stated on decal or rear panel of the
fixture.
This product is intended for indoor use only!
To prevent risk of fire or shock, do not expose fixture to
rain or moisture. Make sure there are no flammable
materials close to the unit while operating.
The unit must be installed in a location with adequate
ventilation, at least 50cm from adjacent surfaces. Be sure
that no ventilation slots are blocked.
Always disconnect from power source before servicing or
replacing lamp or fuse and be sure to replace with same
lamp source.
Maximum ambient temperature is Ta: 40°. Do not operate
fixture at temperatures higher than this.
In the event of serious operating problem, stop using the
unit immediately. Never try to repair the unit by yourself.
Repairs carried out by unskilled people can lead to
damage or malfunction. Please contact the nearest
authorized technical assistance center. Always use the
same type spare parts.
Dont connect the device to a dimmer pack.
Make sure power cord is never crimped or damaged.
Never disconnect power cord by pulling or tugging on the
cord.
Caution! There are no user serviceable parts inside the unit. Do not open the housing or
attempt any repairs yourself. In the unlikely event your unit may require service,
please contact CHAUVET.
Please read these instructions carefully, which includes important
information about the installation, usage and maintenance?