Filter
Top Products
LX10 7 2/7/2012 10:22 AM
4.
OPERATING INSTRUCTIONS
The LX10 can operate in Sound-Active, Auto, or static mode. The mode is determined by the position
of the switch located on the rear of the unit. To switch between the three modes, place the switch in
either the “I” or “II” position for movement or “O” for static operation.
In the “II” position, the fixture operates in Sound-Active mode, the sensitivity of which can be adjusted
by the knob also located on the rear of the unit. To increase the sensitivity of the unit rotate the knob
clockwise.
In the “I” position the fixture operates in Auto mode. The light will progress through a pre-
programmed routine, whether sound is present or not.
In the “O” position the fixture operates in static mode. The fixture will continue to light without
scanner movement.
Troubleshooting
1) Verify that the unit is plugged into both the wall and the unit, and verify that the fuse is in
working order.
2) If the unit fails to respond, place the unit in auto mode, listening for movement of the
motor inside the case. If no sound is heard from inside the case, replace fuse and retry.
3) If the unit is still not working, verify the integrity of the outlet with another fixture.
If you still have a problem after trying the above solutions, please contact CHAUVET Technical
Support at the location on the next page.
Switch LEDs Motor
I Auto Auto
O Auto Stop
II Sound Sound