Filter
Top Products
LED Pinspot™ 2 User Manual 5 5/10/2010 12:09 PM
Hanging Clamp
Note!
Clamp is sold separately.
Mounting
Orientation
This fixture may be mounted in any safe position, provided there is adequate room for ventilation.
Rigging
It is important never to obstruct the fan or vents pathway. Mount
the fixture using, a suitable “C” or “O” type clamp. Adjust the
angle of the fixture by loosening both knobs and tilting the fixture.
After finding the desired position, retighten both knobs.
When selecting installation location, take into
consideration lamp replacement access and routine
maintenance.
Safety cables must always be used.
Never mount in places where the fixture will be exposed to
rain, high humidity, extreme temperature changes or
restricted ventilation.
Lens Replacement
This fixture comes with an optional lens that modifies the beam angle. Please see the instructions
below for instructions on replacing the lens.
1. Remove the retainer ring.
2. Remove the lens (the lens will fall out without the retainer ring installed).
3. Insert the new lens. Use caution, as it may fall out until the retainer ring is installed in step #4!
4. Install the retainer ring.
5. Assure that the installation is tight.
If the lens is not installed properly, it may fall out. This may be a safety hazard if installed overhead.
Lens
Retainer Ring