Filter
Top Products
Intimidator™ Scan LED 4 2009-06-04/10:14
Rotate manual
focus adjustment
clockwise and
counter-clockwise
to achieve desired
focus.
The fuse is located
inside this
compartment.
Remove using a flat
head screwdriver.
DMX Channel Summary
CHANNEL
FUNCTION
1
Strobe
2
Gobo
3
Color
4
Pan
5
Tilt
3. SETUP
Light Source
The fixture does not use a halogen lamp as its light source. Instead, it uses a high luminosity LED,
which comes preinstalled, and does not need to be setup or replaced.
Manual Focusing
To adjust the focus, please follow the instructions
below:
1) If operating in stand-alone mode, turn the music
down so that the unit temporarily stops any activity.
2) In DMX control mode, create a static scene with
any gobo of your choice pointed to a flat surface,
ideally at a halfway point of the fixture’s total
coverage area.
3) Rotate the manual focus either clockwise or counter-clockwise until the spot is defined by a hard
edge.
Fuse Replacement
Disconnect the power cord before replacing a fuse and always replace it with the
same type of fuse.
With a flat head screwdriver, wedge the fuse
holder out of its housing. Remove the blown
fuse from its holder and replace with the exact
same type of fuse. Insert the fuse holder back
in its place and reconnect power.