Filter
Top Products
4
80ED Spotting Scope
25mm Plossl Eyepiece 1
1
/
4
” (24x)
45° Erect Image Diagonal – 1
1
/
4
”
6x30 Erect Image Finderscope
Lens Caps
¼ x 20 Dovetail Mounting Adapter
Take a few minutes to study the diagram below to help familiarize yourself with the various parts of
your spotting scope for set up and ongoing use.
Figure 1 – Wide View spotting scope shown on optional tripod
Removing the Lens Cover
To protect your spotting scope, the objective lens, focuser, and accessories are fitted with protective
covers. All are tension-fitted and easily removed by pulling off. The covers should be removed as
each piece is installed. Once removed, place the covers in the box to ensure they won’t get lost.
Attaching the Standard Accessories
With your spotting scope attached to a sturdy mount, as described earlier in this manual, you are
ready to attach the standard accessories. To do this:
1. Remove the protective covers from the focuser of the spotting scope, the 45º Erect Image
Diagonal, and the eyepiece.
2. Loosen the thumbscrew on the focuser of the spotting scope so that the opening (i.e., inner
diameter) is unobstructed.
3. Slide the chrome barrel of the 45º
Erect Image Diagonal into the focuser
barrel.
4. Tighten the thumbscrew on the focuser
to hold it in place.
5. Loosen the thumbscrew on the
eyepiece holder of the 45º Erect Image
Diagonal. Make sure that it does not
block the inner diameter of the
eyepiece holder.
Figure 2
Objective Lens
Quick-release
Finderscope
Bracket
45º Erect Image
Diagonal
Focuser Knob
Tube Ring
Clamp
Finderscope
Eyepiece
Dovetail / Photo
Tripod Mount
Focuser