Filter
Top Products
12
lIghT BUlB aNd glaSS INSTallaTION
Screw the two bulbs into the light xture as
shown in Figure #1.
When replacing the bulbs, be sure to use only
50-watt maximum.
(not to scale)
Align the glass shade up with the bottom of
the fan as shown in Figure #2 and locate the three
glass holding slots. Then locate the three glass hold-
ing tabs, located on the light xture plate.
Carefully lift the glass globe up inside the
light xture as far as it will go. Rotate the shade in a
counter clockwise direction as shown in Figure #3,
until the glass globe is held tightly in place by the
three tabs.