Filter
Top Products
5
HANGING THE FAN
Step 3. To hang the fan body in the
canopy, hold the fan body firmly and in-
sert the ball into the canopy opening.
Check that no wires were pinched. Ro-
tate the fan body until the slot in the
ball fits into the pin opposite the canopy
opening.
CAPPED
BLUE
D1-OPTION
WIRE
PIN
SLOT
BALL
CANOPY ELECTRICAL CONNECTIONS
CANOPY INSTALLATION
CANOPY LOCK
WASHERS
CROSSBAR MOUNTING
BRACKET INSTALLED
CANOPY
Note: On sloped ceilings, align the
canopy opening toward the top or
room peak.
Step 2. Thread the wires from the ceiling through
the opening in the canopy. Attach the canopy to
the crossbar mounting bracket with three of the
8-32 x 2
1
/4″ long canopy screws and canopy lock
washers.
Using the screwdriver, tighten the screw firmly by
hand only.
UTOPIAN
CANOPY
SCREWS
Step 4a. Attach the fan wires to the ceiling fixture outlet
box wiring by placing the bare ends of the wires side by side
and then securing with a wire nut. Test that the connection
is secure by pulling on the wire nut. Connect in this order:
Step 4b. Pull Chain Connections
• GREEN leads from mounting plate and fan to GROUND con-
ductor of power source. Secure with wire nut.
• WHITE wire from fan to white NEUTRAL wire in ceiling
fixture outlet box. Secure with wire nut.
• BLUE wire and BLACK power wire from fan to BLACK power
wire in ceiling outlet box. Secure with wire nut.
2 WHITE WIRES
2 BLACK WIRES
WIRE NUT
3 GREEN WIRES