Filter
Top Products
Error Messages 3-3
Error Message Chart
Follow suggested procedures for the error indicated on the host machine (printer).
*1
If this error message appears when the conveyor is not full, trim may be blocking the sensor.
Cause of Error Remedy
The top cover is open. Close the top cover .
The conveyor is full.
*1
Lift the E handle and remove the booklets from the con-
veyor.
The trim box is full. Empty it. If there is trim left in the delivery chute, remove
the trim.
A booklet jam has occurred at the
entranc
e of the
two-knife trim section.
Open the delivery section cover of the upstream trim-
mer and the top cover of the two-knife booklet trim-
mer-A1. Open the
A and F2 transport unit, and
remove the
jammed booklet. Reposition the A and
F2
transport unit and close the top cover and the
delivery section cover to restart printing.
A booklet jam has occurred in the two-
knife trim
section.
Open the top cover of the two-knife booklet trimmer-
A1. Open the F2 transport unit and remove the
jammed booklet. Reposition the F2 transport unit and
close the top cover to restart printing.
A booklet jam has occurred at the exit of
the
two-knife trim section.
Open the top cover of the two-knife booklet trimmer-
A1. Open the F2 transport unit and remove the
jammed booklet. If necessary, also hold the E handle
and
lift the conveyor. Reposition the E and F2 trans-
port unit and close the top cover to restart printing.
2
1
3
A
E
F2
1
2
1
1
2
1
1
1
1