Campbell Hausfeld PW1345B Pressure Washer User Manual


 
13 mm
Interruptor
Manguera
de alta
presión
Salida
Entrada (Vea la
conexión de la
manguera en
página 1)
Pistola
11 Sp
Instrucciones de montaje y lista de piezas PW1345B
4. Conecte la manguera de jardín según
se explica en Instrucciones de conex-
ión de la manguera de jardín.
5. Enchufe el cordón de corriente en un
tomacorrientes de 120 V con conex-
ión a tierra.
6. Abra la llave del agua.
7. Oprima el gatillo y manténgalo pre-
sionado por 1 minuto para liberar la
presión y liberar el aire atrapado en
el sistema.
8. Coloque el interruptor "ON/OFF"
(ENCENDIDO/APAGADO) en la
posición "ON" ("ENCENDIDO").
NOTA: LAS INSTRUCCIONES DE FUN-
CIONAMIENTO SE ENUMERAN EN EL
MANUAL DEL PRODUCTO.
1. Inserte la lanza en la pistola y gírela
en el sentido de las agujas del reloj
hasta que llegue a su tope, como se
muestra en la figura 4.
2. Verifique que el interruptor esté en
la posición "OFF" ("APAGADO").
3. Conecte la manguera de alta presión
y el ensamblaje de la pistola en la
unidad.
Conexión del Sistema
Figura 4 - Conexión de la pistola y lanza
Figura 5
! IMPORTANT !
This pressure washer is equipped with
a microswitch sensitive to water flow.
This Instant Start/Stop switch (ISS)
senses water flow in the pump. When
the trigger is released, water stops
flowing through the pump. The ISS
then automatically turns the motor
off to protect pump from overheat-
ing.
OPERATION
1. Turn the ON/OFF switch to ON.
2. Pull trigger on gun to begin spray-
ing water.
3. Release trigger. The pressure wash-
er motor will stop running.
4. To spray again, pull trigger and
motor and pump will restart.
Note: Occasionally the motor may
run for a short time to bring fresh,
cool water into the pump even if trig-
ger is released. This is part of normal
operation and will not damage the
unit.
Always turn the
“ON/OFF” switch to
“OFF” then trigger gun to release
hose pressure before unplugging
power cord.
Risk of Injection.
Unit will start spray-
ing when trigger is squeezed if
on/off switch is in “ON” position.
Always point gun in safe direc-
tion.
!
WARNING
!
CAUTION
Call 1-800-330-0712
for Technical Service
Power Cord
1. Plug the power cord into a ground-
ed 120V outlet and press the reset
button as shown in figure 3.
2. THIS MUST BE DONE EACH TIME THE
UNIT IS PLUGGED IN AN OUTLET.
Reset
Figure 3 - Grounded plug/reset button
Assembly Instructions and Parts List PW1345B
2
www.chpower.com
Enchufe GFCI