Filter
Top Products
Pressure Washer
How do I start my pressure
washer?
1. Make sure you have gas and oil in the engine. The
engine DOES NOT COME FILLED WITH OIL.
2. Turn the water on, then trigger the gun to make sure the
water will flow smoothly out of the tip.
3. Open the fuel shutoff valve by turning the knob
counterclockwise until it stops.
4. Close the choke (if engine is cold) by moving the choke
ring fully to the right.
5. Set the shut off switch to “ON.”
6. Pull the trigger (to relieve any back pressure in the pump)
while pulling the starter cord.
What type of oil do I use?
ENGINE DOES NOT COME FILLED WITH OIL: See Page 10 for
engine oil types, quantities, and oil changing instructions.
Pump: The pump comes filled with the correct amount of
oil and should not need changing or filling.
Why don’t I have any water
pressure?
• Is the water hose attached to the pressure washer?
• Is the water turned on?
• Check for any kinks, leaks, or blockage in the hoses,
fittings, or the nozzle.
• Is the 15º (yellow) spray tip inserted into the end of the
lance (See Page 8)?
• Is the inlet filter screen free of debris? Check and remove
debris if needed.
How do I get high pressure?
• For high pressure, insert the 15º (yellow) spray tip into
the end of the lance (See Page 8).
How do I get the soap suction to
work?
1. Attach clear plastic tube to barb on pump (see Figure 2
on page 5).
2. Put the other filter end of the clear tube into the
detergent container.
3. Install the black spray tip to apply low pressure
detergent.
3
Why doesn’t the pressure
washer apply detergents with
high pressure?
Detergents “bounce” off cleaning surfaces as fast as they are
applied. The pressure washer’s features allow for a detergent
to be drawn while in low pressure mode only. By applying
detergent at low pressure, the effect of “bouncing” is
reduced. Also, detergents are only effective when time is
allowed for them to work on the surface of whatever is
being cleaned. After applying the detergent, wait 1-3
minutes while it works, and then proceed to rinse the surface
with high pressure.
What maintenance do I need to
perform on my pressure washer?
1. After turning off the pressure washer and the water,
depressurize the hose by triggering the gun.
2. Remove the garden hose and high pressure hose from the
pump.
3. Pull the start rope slowly five times to purge water from
the pump. This will help protect the pump from damage.
4. Do not store your pressure washer in an area where the
temperature will drop below 32˚ F.
5. Follow proper storage and winterizing instructions found
on page 9.
What do I do if I’m missing a
part?
Call Maxus at 1-888-Maxus4U and we will promptly replace
your missing parts. DO NOT RETURN THE PRESSURE
WASHER TO THE RETAILER!
Where can I buy accessories for
my pressure washer?
• If you can’t find accessories at the store where you
purchased your pressure washer, call Maxus at 1-888-
Maxus4U or visit our website at www.maxustools.com.
Who do I call if I have questions
or problems?
Call Maxus at
1-888-Maxus4U (U.S.A.)
www.maxustools.com
Frequently Asked Questions